Instructions for fitting the individual protective lenses for your phone's cameras:

Clean the camera lenses:
Use a soft, lint-free cloth to gently wipe the lenses.
Make sure no residue or dust particles remain.

Remove the protective film:
Remove the protective film from the adhesive side of the protective lenses.

Apply the protective lenses:
Carefully placeeach protective lens over the corresponding chamber.
Gently press on the edge of each lens to ensure an optimal fit.

Finalise the assembly:
Check that the lenses are securely fitted and that there are no air bubbles or impurities.

Caution.
Remove the phone case before mounting.

Optimum environmental conditions:
Install in a low humidity environment (below 60%).
Ambient temperature should be above 20°C.

Use isopropyl alcohol:
If using isopropyl alcohol for cleaning, wait until completely evaporated before installation.

Avoiding condensation:
If the phone has been in a cold environment, allow it to reach room temperature (minimum 20°C) before installation.

Vetter constantly endeavours to maintain the accuracy of the information on this page. However, small errors may occasionally occur: the images are for illustration purposes only and may include accessories that are not part of the standard package.